Composite Gates North Berwick
Composite and metal driveway, side and garden gates, made to measure for your opening and fitted across North Berwick, Dirleton, Gullane and Whitekirk. Every gate is measured on site, built to those measurements, and installed by the same people who quoted it.
What we make and fit
- Composite driveway gates Single, double and sliding, made to the opening.
- Side and garden gates Side, back and pedestrian gates in matching board.
- Metal gates Steel and aluminium, powder-coated to a colour you choose.
- Composite fencing Matching fencing and screens to run on from the gate.
- Automation An option on most gates, specified at survey rather than added later.
Wind from two directions
North Berwick sits on a point, with water to the north and to the east, and that is the detail that matters for a gate. Most exposed sites take their weather from one prevailing direction and can be planned around it. Here a frontage can be sheltered on a westerly and fully exposed on a north-easterly off the Forth, so there is no orientation that reliably gets away with it.
The consequence is that a tall, fully boarded pair behaves like a sail, and the load does not land on the gate — it lands on the hinges and, through them, on whatever the posts are set in. Gates on seafront and near-seafront plots here fail at the fixings far more often than they fail in the middle. The usual answers are a partly open infill, a lower top rail, or heavier posts set deeper; which one depends on the plot and on how much privacy you actually want.
The other local point is the stone. A lot of the older garden walls here are red sandstone, which is softer than it looks and weathers at the face. On an exposed frontage that is the worst combination — the highest load meeting the least reliable fixing — so what the hinge goes into gets checked before anything is made.
What affects the cost in North Berwick
- Exposure of the frontage — the more open the plot, the heavier the posts and fixings, whatever the gate is made of.
- Height and infill — a solid infill takes far more wind load than a partly open one, and drives the specification.
- What the posts are set in — soft sandstone or shallow ground can mean deeper or wider foundations.
- Coastal finish specification — a higher grade of finish and better fixings on the frame, hinges and ironmongery.
Common questions
Will a composite gate cope with the exposure here?
The board itself will. The colour runs through it, there is no coating for salt to lift, and it does not rot or need repainting. What needs care is everything the board hangs on — the frame, the hinges, the fixings and the posts. That is where coastal gates fail, and it is specified rather than assumed.
Do I have to give up privacy to survive the wind?
Not entirely, but there is a real trade-off. A fully boarded gate takes the most load; a partly open infill or a lower top rail sheds it. On a very exposed plot the honest answer is that you can have a solid gate, but it needs heavier posts and deeper foundations to stay put — and that is a cost, not a compromise in appearance.
Do you cover Gullane, Dirleton and Aberlady?
Yes, along with Whitekirk, Tyninghame and the coastal villages. Send your postcode and you will get a straight answer either way.
Nearby
North Berwick is covered from our Lothian page, which lists every town in the region. See also areas we cover.
Free survey and written quote. No obligation, and a straight answer on whether we cover your postcode.
Get a free quote Call 0131 357 6167